Ericsson Mini Link Cli Commands Jun 2026

configuration rollback : Reverts the system to a previously saved stable configuration state if a newly applied change breaks connectivity.

This command typically returns a table of KPIs (Key Performance Indicators) like:

Here is a typical workflow for configuring a new MINI-LINK node using the CLI.

reboot : Restarts the network element. Use with caution on live production traffic. Interface and Radio Link Configuration

test radio loopback remote 1

Before entering commands, you must establish a connection.

help or ? : Displays available commands in the current context. Essential CLI Commands by Category 1. System Information & Status Check

Ericsson MINI-LINK microwave systems are the backbone of mobile backhaul and fixed wireless networks worldwide. While modern network management systems (NMS) provide graphical interfaces, mastering the Command Line Interface (CLI) is essential for rapid troubleshooting, automation, and precise configuration.

set radio-link loopback far-end — Commands the remote ODU to loop back the received RF signal. ericsson mini link cli commands

Ericsson MINI-LINK CLI Commands: The Complete Configuration and Troubleshooting Guide

class-map voice match ip dscp ef class-map data match ip dscp af31

If a link is down or performance is poor, these commands help diagnose the issue. show alarm active Use code with caution. Check Ethernet Performance: show performance interface eth Use code with caution. View Power Levels (RSL): show radio-link performance rsl Use code with caution. 7. Best Practices for MINI-LINK CLI

show radio detail [slot/port] : Provides deep diagnostic metrics for a specific radio terminal, including Far-End information. configuration rollback : Reverts the system to a

copy running-config backup-config — Creates a local recovery point on the node.

show policy-map interface ethernet 1 # Packet matches, drops, queuing stats

Use FTP/SFTP to pull the startup-config regularly.