Ua300 Factory Reset: Zkteco

Before starting the reset process, consider the impact on your data:

⚠️ A factory reset is destructive. It will erase all user data, administrator settings, fingerprint templates, and transaction logs from the device.

If you have ZKTECO's software (e.g., ZKTECO Attendance Management Software) installed on your computer, you can perform a factory reset using the following steps:

If you currently have Supervisor or Admin access, do not open the device. Use the on-screen menu: zkteco ua300 factory reset

After a successful factory reset, use the following default credentials to access the menu:

Below is a comprehensive guide detailing the methods, safety precautions, and post-reset steps for the ZKTeco UA300. Important Pre-Reset Warning

Verify admin identity using the registered admin fingerprint, card, or password. Step 2: Navigate to System Settings Use the arrow keys to select and press M/OK . Before starting the reset process, consider the impact

The is a fingerprint-based access control and time attendance terminal. It supports:

Remove the screws on the back cover and carefully open the housing.

If the UA300 is already connected to your local network via TCP/IP, you can use ZKTeco’s official PC software to reset it remotely: Use the on-screen menu: After a successful factory

If you can still access the device menu, this is the most straightforward method: Navigate to (Data Management). Factory Reset Initialize Confirm the action. This will erase all user data, logs, and settings. Method 2: Reset via ZKTime Software

If you are locked out because you forgot the admin password, you can use the tamper switch located on the back of the device: the device. Locate the Tamper Switch (a small button or magnet sensor on the back). the device while holding down the tamper switch.