Commax Dp-ra01 Installation Manual Jun 2026

The power supply unit provides power to the entire system. Follow these steps:

The provides the essential setup blueprint for this reliable 1-to-2 audio intercom system. Designed primarily for residential applications, this handset-based system integrates seamless communication between an outdoor door station and up to two indoor room units, complete with electronic door release functionality.

The DP-RA01 typically uses a . If you are pulling new cables, you will need "Quad Wire" (4 cores). commax dp-ra01 installation manual

Do not connect the electric lock directly to the communication lines. The door release mechanism must be powered by an external AC/DC transformer matched to your lock's rating.

The is a wall-mounted room unit (handset) designed for single-house doorphone systems. It primarily functions as an intercom to communicate with a door station and control an electronic door release. Pre-Installation Safety Guidelines The power supply unit provides power to the entire system

The master door station must be programmed to call the correct monitor ID number. Refer to your door unit manual for call routing.

If you are planning to install this, would you like help with: The DP-RA01 typically uses a

Hold the bracket against the wall, mark the screw holes, drill the pilot holes, and insert the wall anchors.

: The master unit (DP-RA01) typically plugs directly into a standard AC 100-240V

Up to 100 meters (using 0.65mm copper wire).

Follow these sequential instructions to install the Commax DP-RA01 handset safely and securely. Step 1: Choosing the Mounting Location