Check that the linking cable is completely pushed into both the receiver and the camera body port. Shutter stays open permanently

Turns the device on/off or locks buttons to prevent accidental changes. Power Button: Press and hold to power the unit on or off.

Older WTR2 versions use a 12-bit DIP switch inside both the transmitter and receiver.

Always switch your camera lens to Manual Focus (MF) once you have acquired your initial focus point. If left on Autofocus (AF), the camera may fail to confirm focus on a dark interval frame, skipping that shot entirely. Troubleshooting Guide Camera does not fire, but receiver LED lights up red

USB-C ports are used for recharging the internal batteries. 4. Initial Setup and Pairing Charge the Units: Connect both the transmitter ( ) and receiver ( ) to a power source using the provided USB-C cables. Attach Receiver: Slide the receiver ( ) onto your camera’s hot shoe.

) can be used directly on the camera without the transmitter for a compact setup. Plug it in and use its shutter button directly. C. BULB Mode for Long Exposure Set your camera to mode.

The WTR-2 Manual (FCC ID) is a multifunctional, rechargeable intervalometer and wireless remote shutter release Product Page . It consists of two units: a Transmitter ( ) and a Receiver (

Check if the receiver power is active and the LED flashes when commands are sent. Ensure the 2.5mm cable is pushed completely into both the receiver and the camera ports. Verify that the transmitter and receiver are set to the exact same channel.

Backlights the LCD screen for use in low-light conditions. [3, 4] Technical Specifications 80m+ (Open area) Battery (Transmitter) Battery (Receiver) LCD with backlight button combinations for setting up a time-lapse, or are you looking for the battery installation

Aside from timing, the device offers four standard release modes: : Standard one-off photo. B (Bulb) : Manual long exposure control.

: Ensure the camera is set to the correct remote or drive mode as required by your specific camera model.

Transmitter up to 3 years; Receiver up to 2,000 hours standby Hardware Overview

The system consists of two main units: a transmitter and a receiver. The receiver connects to the camera, while the transmitter allows you to trigger the shutter from a distance, reducing camera shake and allowing for creative, unattended shooting.

Specifies how many photos the timer will shoot during the current program. You can set any value from 1 to 199 – or select “‑‑” for an unlimited number of shots (the camera will keep shooting until you stop it or the batteries die).