Q: Can I update the BND50 SE36 software and firmware? A: Yes, regularly update the device software and firmware to ensure optimal performance and security.
Before programming, you set the current time.
To restore your BND50 SE36 to original state:
Tip: If you want the timer to start in the middle of a current "ON" cycle, cycle the button from →right arrow AUTO while the current time is within a programmed window. 5. Special Functions
Before starting, ensure all the gray pins around the outer edge of the dial are . In this position, the timer is in the "OFF" state. 2. Set Your "ON" Times Each pin represents a
If your programs overlap, the timer may not function as expected. Review all 8 program slots by cycling through PROG .
If you’re missing a step-by-step for your exact printer, Bondtech’s generic LGX manual with your printer’s extruder replacement guide. The SE36 motor behaves like a standard NEMA 17 but with lower inductance—so avoid high microstepping (1/16 is fine) and keep wiring carefully verified.
The (or ON/AUTO/OFF ) selector changes how the hardware behaves relative to your saved schedules:
This section assumes you have the with remote model SE36.
Press the PROG (or "Timer") button once. The screen will display "1 ON."
Press the PROG button once. You will see "1 ON" on the display.
: Rechargeable Ni-MH (retains settings during power outages) Initial Setup and Battery Charging
Overrides or recovers a specific program setting.
For your programmed schedules to actually work, you must set the device to the correct mode using the button: ON: Power is always on (manual override). OFF: Power is always off (manual override). AUTO: The timer will follow your programmed schedules. 4. Advanced Features
This comprehensive guide provides everything you need to know to program, operate, and troubleshoot your BND50 SE36 timer. 📌 Technical Specifications
: If your model has a physical switch on the side, make sure it's not in the "Off" or "Override On" position, as this will bypass the timer program.