Hitarget V30 Plus Manual Upd Instant

If the base is on a known point, enter the coordinates. If on an unknown point, select Average Position or "Single Point". Click Apply . 4.3 Configuring Rover Station (UHF Radio) Disconnect from Base and connect to the Rover V30 Plus. Go to Device -> Rover Setting . Set Data Link to Internal UHF .

Turn on the iHand controller and open the survey software (e.g., Hi-Survey Road). Go to Device > Connect Select the Bluetooth serial number. Setting Up a Base Station Select Survey > Base Setup .

The is a GNSS RTK receiver designed for high-accuracy surveying, utilizing multi-constellation tracking (GPS, GLONASS, Galileo, BeiDou) to provide reliable positioning in challenging environments. This article serves as an in-depth, user-friendly guide to understanding and operating the V30 Plus system. 1. Introduction to the V30 Plus

Ensure no other controller is paired with the receiver. Restart both the receiver and the controller.

Import your design coordinates via a CSV or DXF file, or select a point from your current library. hitarget v30 plus manual

Features tilt compensation (Slope Method 2.0) with an accuracy of approximately 8 mm + 0.7 mm/° tilt.

The Hi-Target V30 Plus is typically paired with software on an Android controller (like the iHand series).

Always wipe down the receiver with a dry microfiber cloth after working in wet or muddy conditions. Never use harsh chemical solvents on the casing.

Features calibration-free tilt compensation for faster measurements without perfectly leveling the pole. If the base is on a known point, enter the coordinates

Select your broadcast frequency/channel (e.g., Channel 1, 460.125 MHz) and protocol (e.g., HI-TARGET or TRIMTALK).

Touch the controller (e.g., iHand30) to the NFC logo on the V30 Plus.

V30 Plus GNSS RTK User Manual | PDF | Battery Charger - Scribd

Measure the carefully (refer to manual for vertical or slant height). Screw on the UHF antenna. 3.2 Powering On Turn on the iHand controller and open the survey software (e

The receiver body is constructed from chemical-resistant, high-impact polycarbonate materials. It features an IP67 environmental rating, protecting the system against dust ingress and immersion in water up to 1 meter. V30 Plus GNSS RTK System User Manual

Tap the correct SN to establish a secure wireless connection. Configuring Rover Mode (CORS / NTRIP) Once connected, go to > Rover .

Name the point, enter the feature code (e.g., TOPO, TREE, CURB), and verify the pole height is correct (usually 2.000m).