Siruba+l818fm1+error+list+2021 __top__
If you need help with a specific code or setting, please let me know: The exact showing on your display screen
Compressed air or a small nylon brush should be used to clear out the feed dogs, throat plate underside, and bobbin case area every evening. Lint buildup is the primary driver behind Err-04 jams.
Turn off the power, manually rotate the handwheel to make sure the needle is moving freely, and ensure the needle is in the upper position. Restart the machine. If the problem persists, check the needle position sensor connection on the motor. 2. ERR 4 - Limit Error (Feed Limit)
Includes programmable back-tacking and automatic thread cutting (scissor function). siruba+l818fm1+error+list+2021
Ensure the machine is not near high-frequency machinery. 4. ER-11: Presser Foot Safety Switch Error
However, based on the standard error code structure for Siruba’s industrial overlock and interlock machines (including L818F series), here is a and how to troubleshoot them. For precise 2021 machine firmware, always refer to the manual supplied with your specific unit.
The automatic thread cutting or production counter has reached zero. If you need help with a specific code
| Code | Description | Probable Cause | Solution | | :--- | :--- | :--- | :--- | | | Main Motor Lock / Overcurrent | The motor is physically blocked or the internal wiring is shorted. | 1. Turn off power. Check if the handwheel is jammed by thread or fabric. 2. Check the motor cable connection between the motor and the control box. 3. If the problem persists, the motor driver board may be damaged. | | E02 | Overvoltage | Input voltage is too high (usually above 260V). | 1. Check the power supply voltage in your facility. 2. Use a voltage stabilizer if necessary. | | E03 | Undervoltage | Input voltage is too low. | 1. Check power connections. 2. Ensure the power plug is secure. | | E04 | Motor Phase Error | The machine cannot detect the motor position. | 1. The connector cable between the motor and control box is loose or disconnected. 2. The motor sensor (encoder) is faulty. |
Check the handwheel alignment. Ensure the internal magnet or optical sensor disk is clean and free of lint or oil accumulation.
Check the under-bed thread trimmer mechanics to ensure nothing is jammed or mechanically binding. Reset the power to allow the machine to re-home. 4. ERR 10 - Counter Set to 0 Restart the machine
: Dust and lint accumulation can cause false sensor readings. Use a soft brush to clear out the feed dog slots, knife paths, and the under-bed automatic trimmer area.
Direct-drive machines rely heavily on precise communication between the motor encoder and the main control unit. When signals drop, the machine halts to prevent mechanical timing damage. E09 / E11: Positioning Signal Error
If you are dealing with a specific error on your machine panel right now, tell me and what the machine was doing when it stopped. I can give you the precise mechanical fix.
: Signals from the position detector (UP/DOWN signals) are broken or the connector is loose.
