Pigmented lesions, vascular treatments, photo-rejuvenation, and hair removal. ResurFX™
Operating the system requires professional training; the manual is not a substitute for physician certification. lumenis.com Lumenis Stellar M22 Operator's Manual | PDF - Scribd
The M22 utilizes an internal water cooling system. Check the water level indicator monthly and top off with distilled water as specified by the manufacturer.
The interface on the front of the machine where handpieces are connected and automatically recognized by the system.
Check the cooling water level at the back of the console before turning the machine on. lumenis m22 user manual
Press the Ready button. The system will perform an internal calibration test. Once calibrated, the handpiece indicator light will turn green. Step 4: Handpiece Placement and Pulse Delivery
All personnel and the patient must wear wavelength-specific safety eyewear inside the treatment room.
Remedy: Check the water window on the back panel, straighten the handpiece cord, and restart the machine to purge air bubbles.
Wait for the system to pass its self-test. If a calibration error occurs, clean the handpiece tip and retry. Parameter Selection Guidance Check the water level indicator monthly and top
A 1064 nm Q-Switched laser used for tattoo removal and pigmented lesion treatments. It delivers high-peak-power nanosecond pulses to mechanically shatter ink particles and deep dermal pigment. 3. Operational Workflow and Safety Protocols
| Error Code / Message | Likely Cause | User Manual Solution | | :--- | :--- | :--- | | | Handpiece not recognized | Reseat the handpiece in the cradle. Power cycle the system. If persists, test with a different handpiece. | | "Coolant Flow Low" | Air in the cooling line or low coolant | Do not pulse. Power off. After 30 min, check coolant level. Call service if full. | | "Energy Output Out of Spec" | Dirty optics or failing flashlamp | Clean the handpiece window. If error remains, the flashlamp module needs replacement (every 100,000 pulses or 12 months). | | "DCD Gas Empty" | Cryogen canister depleted | Replace the DCD cartridge (part # M22-DCD-1). The manual provides step-by-step replacement instructions. | | "Footswitch Unresponsive" | Faulty cable or USB connection | Unplug and replug. Try a different footswitch. Replace the cable if damaged. |
: Homogeneous, flat-top beam profile engineered for precise pigment shattering, skin toning, and multi-colored cosmetic tattoo removal. 3. Pre-Treatment Checklist & Clinical Safety
A 1565 nm fiber laser designed for non-ablative fractional skin resurfacing. Press the Ready button
The IPL handpiece does not recognize the inserted ExpertFilter.
Features multiple spot sizes (2x4 mm, 6 mm, and 9 mm).
Turn the control key clockwise to start the operating system.