Close
Attach the to a heavy, unpainted metal part of the engine block or frame (this is called "chassis ground"). Note: If your manual permits, you can connect it directly to the negative battery post, but chassis ground is generally safer to prevent sparks near the battery. Step 3: Powering Up and Selecting Modes
Use the to select the appropriate charging speed (2A, 10A, or 15A) and your battery type (Standard or AGM).
| Fault Code | Meaning of Fault Code | Recommended Action | | :--- | :--- | :--- | | | Internal Shorted Cell Battery – Battery cannot be charged. | Have battery checked by certified auto service center. Check for excessive load on battery while charging. | | F02 | Bad Battery Connection / Voltage Too Low – Loose clamps or battery is too dead to accept charge. | Check battery connection and tighten clamps. Have battery tested. | | F03 | Internal Open Cell – Battery has internal damage. | Have battery checked by certified auto service center. | | F04 | Overtime Condition – Battery has not finished charging after 18 continuous hours. | Battery may have internal damage or sulfation. Have battery checked. | | F05 | Overheated Condition – Charger or battery is too hot. | Disconnect charger and allow to cool for 30 minutes. Check for ample ventilation. | | F06 | Reverse Polarity – Red is on Negative, Black is on Positive. | Immediately reverse the clamps. Connecting backwards can damage the charger. | | F07 | Alternator Output Out of Range – Issue with vehicle charging system. | Check vehicle alternator output voltage. |
Never attempt to charge a battery while the engine is running. everstart 6811a smart charger manual
: Avoid touching clamps together when the charger is plugged in.
No. The 6811A is a charger and maintainer, not a jump starter. It lacks the peak amperage required to crank an engine instantly. You must leave it connected for several hours to restore starting power. Can I charge lithium-ion batteries with this?
This model is typically manufactured by Schumacher Electric for Walmart. If you search for "Schumacher SE-1010D manual" or "EverStart 6811A manual PDF" on the Schumacher website or ManualsLib, you will usually find the exact digital copy. Attach the to a heavy, unpainted metal part
The screen shows "FUL" or a green light turns on. The device drops into float mode to prevent overcharging. Step 5: Disconnect Safely
: The battery cannot hold a charge and likely needs to be replaced.
2A (Maintainer), 10A (Fast Charge), 50A (Engine Start) Battery Compatibility: Standard Lead-Acid, AGM, and GEL | Fault Code | Meaning of Fault Code
This is the most common complaint about this model. It needs a minimum voltage (roughly 3-5 volts) to "sense" the battery before it will start charging.
Lead-acid, Gel, and AGM (Absorbent Glass Mat). Input: 120V AC, 60Hz, 0.76A.
Connect the charger clamp to the free end of the extra cable you attached to the negative post. 4. Charging the Battery
volts) for the charger to recognize it. If it jumps immediately to
