V2000-c Rfid Access Control User Manual [top] Jun 2026

The V2000-C is a "Standalone" unit, meaning it does not require a constant network connection to work, but it can connect for management.

Connect the positive wire of the lock to NO , the negative wire of the lock to GND , and bridge COM to +12V . When power is lost, the lock remains secured. V2000-c Rfid Access Control User Manual

is a standalone RFID access control system designed for single-door security. It supports up to 1,000 users The V2000-C is a "Standalone" unit, meaning it

The V2000-C is a 125KHz RFID standalone access control keypad designed for single-door security, supporting up to 1,000 users with card or PIN access. Programming involves entering a master code to add/delete users, configure door open times, and manage system settings. Official digital copies of the V2000-C User Manual are available at www.goldbridgesz.com is a standalone RFID access control system designed

| Buzzer Signal | Meaning | |:-------------|:--------| | One short beep | Operation accepted / key press registered | | One long beep | Operation successful (card added/deleted) | | Continuous short beeps | Alarm triggered (anti-tamper) | | Intermittent beeps + flashing LEDs | Initialization in progress | | 3 beeps | Duplicate registration attempt | | 4 beeps | Memory full |

The V2000-C identifies users by an allocated User ID slot (from 1 to 2000). Keeping an external paper or digital log of which user is assigned to each ID slot is highly recommended for easy maintenance. Adding Users Add Card Users (By Swiping) Enter Programming Mode. Press 1 + Swipe Card + # . Repeat for consecutive cards, then press * to exit.