: Because these tools interact with hardware at a low level, they are often flagged as "False Positives." Ensure you download from trusted sources.
WHAT DO YOU NEED TO FORGIVE?
| Symptom | Possible Cause | Recommended Fix | |---------|---------------|------------------| | | The driver or USB port is not friendly to low‑level access. | Try a different USB port, run the tool as administrator, or use an older version of the MP tool (e.g., 20191210). In some rare cases, the USB device itself may be physically damaged. | | “Please insert a disk into the drive” error | The drive has lost its partition table or file system. | This is a classic case for the MP tool. Follow the “Finish Product Open Card” procedure to re‑initialize the drive. | | Flash ID not recognized | The tool’s database does not include your specific Flash memory. | Try a different MP tool version. If none works, you may need to manually edit the FlashDB file (advanced) or contact the manufacturer. | | Write failure during programming | Unstable power supply or poor contact. | Use a reliable USB cable or port. For internal memory chips, ensure the power supply is stable (VDD > 3.0V). | | Capacity after repair is lower than expected | The USB drive was previously “fake” (fraudulently reported a larger capacity). | Low‑level format will reveal the true capacity of the Flash memory. You can later use the MP tool to configure any smaller, but fully functional, partition. | | “Check sum” or “Hash” mismatch errors | The firmware file is corrupted or incompatible with the specific Flash chip. | Re‑download the tool from a trusted source and verify that the MD5 hash matches. Try a tool version that explicitly lists your Flash ID. |
After choosing your parameters, click to close out the configuration panel.
: If the drive has many bad blocks, increasing the ECC level (e.g., to 15) can help stabilize it. firstchip chipyc2019 mp tool new
Leave the input field and click OK (for older versions, if prompted, try the default engineer passwords 320 or 8 ). 3. Crucial Scan Settings
Because the chipYC2019 relies entirely on the FC1179 firmware core, you must use the updated versions of the package.
Click the button in the tool. Your drive should appear in one of the blank grid slots.
+-------------------------------------------------------------+ | CHIPGENIUS DIAGNOSTIC REPORT SAMPLE | +-------------------------------------------------------------+ | Controller Vendor : FirstChip | | Controller Part-Number : chipYC2019 / FC1179 | | Flash ID Code : 453C98B37672 - SanDisk [TLC] | | Total Physical Capacity: 32GB (Target for MPTool Recovery) | +-------------------------------------------------------------+ Phase 2: Acquiring the Proper Software : Because these tools interact with hardware at
Preparation: Disable antivirus software temporarily, as these low-level tools are often flagged as "false positives."
A: Leave the password field completely empty and press OK. Most versions do not require a password.
on the NAND chip permanently. It is a repair tool, not a recovery tool.
Standard formatting utilities crash or throw errors. | Try a different USB port, run the
Always source the software from reliable, dedicated flash archive repositories like the official FirstChip MpTools Archive on USBDev .
where the computer sees the drive but cannot access any storage. Key Features of the New MP Tool
Reflashing a USB controller is a highly technical process. Follow these steps carefully to avoid permanently bricking your hardware. Step 1: Identify Your USB Controller