If the software freezes, look for the small reset hole (usually near the charging port) and gently press it with a paperclip.
Used specifically for adjusting the clock and alarm settings. Pairing & Connectivity Turn the device on and press Button (2) until you hear the "Bluetooth Mode" prompt. Enable Bluetooth on your smartphone and search for "Baseus Encok E09" If prompted for a code, enter The speaker supports TF Card (MicroSD)
A: Yes. You can take only the Right or Left earbud out of the case to use in Mono mode. You may need to select "Baseus Encok" in your Bluetooth settings again if switching from Dual to Mono mode.
Adjusts the brightness of the display and ambient nightlights. Rear Ports Micro-USB Port: Charging input for the device. TF / MicroSD Slot: Local audio file playback. Auxiliary Input: 3.5mm audio jack for wired connections. Basic Operations Powering On and Off Press and hold the Power Button for 2–3 seconds. baseus encok e09 manual
Move the audio source closer to the speaker to eliminate potential wireless interference from walls or electronic equipment.
Long press the button until the alarm hour digits begin flashing.
When the alarm sounds, short press any button (except the Light button) to activate snooze mode. The alarm will sound again after 10 minutes. If the software freezes, look for the small
The reliance on short presses, long holds, and double clicks means that without the Baseus Encok E09 manual, an owner is largely left blindly guessing at the clock's operations. The guide successfully acts as the critical operational key that unlocks the value of an otherwise convoluted budget gadget.
Long press the button to turn on the speaker. The device defaults to Bluetooth pairing mode, indicated by a flashing Bluetooth icon.
: Long-press the light button to cycle between high and low display brightness. Enable Bluetooth on your smartphone and search for
Plug the standard USB end into a 5V/1A power adapter or an active computer USB port. A red indicator light will illuminate during charging.
Repeat these exact steps for by cycling to the Alarm 2 icon. Turning Off an Active Alarm (Snooze Mode)
: Enter the settings mode to adjust hours and minutes. Typically, you hold the mode/time button until the digits flash, then use the volume/track buttons to adjust.
Short press the button until the display shows the Bluetooth icon flashing.